1. Once an end user or distributor submits a design utilizing the builder tool, will a mud flap layout be made by our design team? (Select One)(Required)
2. If an OE dealership requests pricing: (Select all that apply)
6. How long does it typically take to get pricing from Kim/Finance Team? (Select One)(Required)
7. How many inches do we cut off the top and side for our “Standard” angle cut? (Select one)(Required)
10. On a scale of 1-10, how would you rate this training? (1 being low, 10 being good)

P: 1-800-248-3855
F: 507-593-7540
Career Opportunities - Privacy Policy - Cookie Policy

© 2023 High Bar Brands All Rights Reserved.

2701 18th St SW
PO Box 740
Owatonna, MN 55060

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.